Swansea (Tasmania) – Lead
2016-2017: Swansea Lead 0.0049mg/L (max), 0.0009mg/L (mean)
Lead Guideline reduced from 0.01mg/L to 0.005mg/L in June 2025. “The concentration of lead in water within premises may be higher, especially in older buildings, due to contact of the water with lead-containing plumbing products (enHealth 2021). A review found several Australian and international studies that detected up to 0.162 mg/L of lead in drinking water due to leaching from lead-containing plumbing materials including taps and lead service lines, suggesting that leaching of lead from lead-containing plumbing materials can be substantial (SLR 2023)… Based on health considerations, the concentration of lead in drinking water should not exceed 0.005 mg/L.”
Swansea (Tasmania) – Chloroketones
11/7/24: Swansea (Tasmania): 1,1,1-trichloropropanone 1.7ug/L
Data are inadequate to set guideline values for chloroketones in drinking water. GENERAL DESCRIPTION The chloroketones are produced in drinking water as by-products of the reaction between naturally occurring organic matter and chlorine. No data are available on other sources or uses for these compounds. Concentrations of chloroketones in drinking water reported overseas are very low and are estimated at less than 0.01 mg/L.
TYPICAL VALUES IN AUSTRALIAN DRINKING WATER In major Australian reticulated supplies 1,1,1-trichloropropanone has been recorded in concentrations up to 0.02 mg/L, but it is usually below the limit of determination of 0.0005 mg/L. No data are available for other chloroketones.
LIMITING FORMATION IN DRINKING WATER The presence of chloroketones in drinking water can be minimised by removing naturally occurring organic matter from the source water, by reducing the amount of chlorine added, or by the use of alternative disinfectants.” 2011 ADWG
Swansea (Tasmania) – Haloacetonitriles
11/7/24: Swansea (Tasmania) Bromochloroacetonitrile 1.8ug/L, Dibromoacetonitrile 1.4ug/L, Dichloroacetonitrile 1.4ug/L
“GUIDELINE
Data are inadequate to set guideline values for haloacetonitriles in drinking water
GENERAL DESCRIPTION
Haloacetonitriles are formed from organic precursors during chlorination or chloramination of drinking water. Concentrations of dihaloacetonitriles reported overseas range up to 0.04 mg/L but are typically less than 0.003 mg/L. Concentrations of trichloroacetonitrile are less than 0.001 mg/L.
Trichloroacetonitrile has been used as an insecticide. No data are available on uses for the other haloacetonitriles.
TYPICAL VALUES IN AUSTRALIAN DRINKING WATER
No data are available on concentrations of haloacetonitriles in Australian drinking waters”. ADWG 2011