2016/23 – Robe (South Australia) – Chloride, Sodium, Total Dissolved Solids

Robe (South Australia) – Chloride

March 14 2017 Robe (South Australia)  Chloride 250mg/L

9/6/20: Robe Chloride 249mg/L (max). 2019/20 av. 211.25mg/L av.

“Chloride is present in natural waters from the dissolution of salt deposits, and contamination from effluent disposal. Sodium chloride is widely used in the production of industrial chemicals such as caustic soda, chlorine, and sodium chlorite and hypochlorite. Potassium chloride is used in the production of fertilisers.

The taste threshold of chloride in water is dependent on the associated cation but is in the range 200–300 mg/L. The chloride content of water can affect corrosion of pipes and fittings. It can also affect the solubility of metal ions.

In surface water, the concentration of chloride is usually less than 100 mg/L and frequently below 10 mg/L. Groundwater can have higher concentrations, particularly if there is salt water intrusion.

Based on aesthetic considerations, the chloride concentration in drinking water should not exceed 250 mg/L.

No health-based guideline value is proposed for chloride.” 2011 Australian Drinking Water Guidelines

Robe (South Australia) – Sodium

30/8/16 Robe  Sodium 253mg/L

22/11/16 Robe Sodium 245mg/L

14/3/17 Robe Sodium 256mg/L

6/6/17 Robe Sodium 236mg/L

2018/19: Robe (South Australia). Sodium 250mg/L (max), 219mg/L (av. 2018/19)

9/6/20: Robe Sodium 257mg/L (max), 222.5mg/L (av. 2019/20)

7/3/23: Robe Sodium 268mg/L (max), 226.5mg/L (av. 2022/23)

“Based on aesthetic considerations (taste), the concentration of sodium in drinking water
should not exceed 180 mg/L….The sodium ion is widespread in water due to the high solubility of sodium salts and the abundance of mineral deposits. Near coastal areas, windborne sea spray can make an important contribution either by fallout onto land surfaces where it can drain to drinking water sources, or from washout by rain. Apart from saline intrusion and natural contamination, water treatment chemicals, domestic water softeners and
sewage effluent can contribute to the sodium content of drinking water.” ADWG 2011

Robe (South Australia) – Total Dissolved Solids

2018/19: Robe (South Australia) Total Dissolved Solids 800mg/L (max), 741.75mg/L (av)

2019/20: Robe Total Dissolved Solids (by EC) 823mg/L (max), 753mg/L av.

2022/23: Robe Total Dissolved Solids (by EC) 801mg/L (max), 739.25mg/L av.


“No specific health guideline value is provided for total dissolved solids (TDS), as there are no
health effects directly attributable to TDS. However for good palatability total dissolved solids
in drinking water should not exceed 600 mg/L.

Total dissolved solids (TDS) consist of inorganic salts and small amounts of organic matter that are dissolved in water. Clay particles, colloidal iron and manganese oxides and silica, fine enough to pass through a 0.45 micron filter membrane can also contribute to total dissolved solids.

Total dissolved solids comprise: sodium, potassium, calcium, magnesium, chloride, sulfate, bicarbonate, carbonate, silica, organic matter, fluoride, iron, manganese, nitrate, nitrite and phosphates…” Australian Drinking Water Guidelines 2011